HD Whoop Drones

Eachine Cinecan 85mm 4K Cinewhoop 3-4S FPV Racing Drone

Eachine Cinecan 85mm 4K Cinewhoop 3-4S FPV Racing Drone

とうとう来ましたね。

Eachineから「Eachine Cinecan 85mm 4K Cinewhoop 3-4S」がリストアップされました。

Caddx Tarsier」採用の4Kフープの登場ですし、価格も$189.00と75mmサイズのCine whoop並みの価格です。

モーターは「EX1103 7000kv」、ESCも「10A continuous peak 12A (5 seconds)」なので3Sでの運用がベストかも知れませんが、非常に楽しみな機体ですね。

Eachine Cinecan 85mm 4K Cinewhoop 3-4S FPV Racing Drone

Eachine Cinecan 85mm 4K Cinewhoop 3-4S FPV Racing Drone

Eachine Cinecan 85mm 4K Cinewhoop 3-4S FPV Racing Drone

Eachine Cinecan 85mm 4K Cinewhoopの仕様

Specifications:

Brand Name: Eachine
Item Name: Cinecan 85mm 4K Cinewhoop
Wheelbase: 85mm
Size: 115mm*115mm*55mm
Weight: 66g(without battery)
Weight:91g(with Original 3s 300mah Lipo battery)

重量は66gって軽いsですね!バッテリー込みで91gなのでBETA85XHDよりも軽量ですね。

付属のバッテリは「3s 300mah Lipo」なので予想通り4Sというよりは3Sでのフライトとなりそうです。この流れだと4S300mAhとかも登場しそうな雰囲気です。

Spare parts specifications:

MotorMode: EX1103 KV7000
Configu-ration:9N12P
Stator Diamter:11mm
Stator Length:3mm
Shaft Diameter:Φ1.5mm
Motor Dimension(Dia.*Len):Φ13.5mm*15.5mm
Weight(g):3.7g
No.of Cells(Lipo):2S-4S
Flight controller(Frsky version) CRAZYBEE F4FR PRO V3.0 Firmware target: CrazybeeF4FR
(Flysky version) CRAZYBEE F4FS PRO V3.0 Firmware target: CrazybeeF4FS
(No RX version) CRAZYBEE F4 PRO V3.0 Firmware target: CrazybeeF4DX
MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
Sensor: MPU-6000(SPI connection)
Board size: 28.5 * 28.5MM
Power supply: 2-4S battery input (DC 7-17V)
Built-in 10A(each) Blheli_S 4in1 ESC Dshot600 ready
Frsky version Built-in SPI Frsky receiver with telemetry(D8/D16 switchable)
Flysky version Built-in SPI Flysky receiver with telemetry(AFHDS/AFHDS2A switchable)
No RX version need to add external Receiver
Built-in Betaflight OSD(SPI Control)
Built-in Current meter Max 70A
Current meter scale set to 470
Built-in 5V 1A BEC
Built-in voltage detection
Onboard 4in1 ESCMCU upgraded to EFM8BB21
Power supply: 2-4S LiPo/LiPo HV (7v/17v)
Current: 10A continuous peak 12A (5 seconds)
Support BLHeliSuite programmable
Factory firmware: F_H_40_REV16_5.HEX
Default protocol: DSHOT600
Frsky NON-EU receiver VersionSPI BUS receiver
Frsky D8/D16 switchable
Compatible Non EU transmitter both D8 and D16 mode
Channels: 8ch or 16ch
Failsafe support
No ground interference ( Transmitter and receiver 1 m from the ground): 300m
Flysky receiver VersionSPI BUS receiver
Protocol: AFHDS and AFHDS-2A Switchable
Channels: 8ch(AFHDS) or 14ch(AFHDS-2A)
No ground interference ( Transmitter and receiver 1 m from the ground): 300m
Failsafe support
TBS Crossfire versionCRSF Protocol , Official TBS transmitter compatible
PNP No RX versionNo RX version support external serial-bus receiver like xm+, crossfire, S-FHSS etc.
VTXOutput power: 25~200mw switchable
Frequency: 40CH
Input voltage: 3.3V 5.5V
Current consumption: 300mA(type)
Antenna: RG178 antenna
Frequency: 5.8GHz 5bands 40 channels
With Race band
Smartaudio ready
Weight: 3g
CADDX TarsierImage sensor: Sony sensor 12M, 1/1.8inch, 1/2.9inch
Horizontal: 1200TVL
TV system: NTSC/PAL changeable
Video Resolution: 4K/30FPS 16:9
2.7K/60FPS 4:3
1440P/60FPS,30FPS 4:3
1080P/90FPS,60FPS,30FPS 16:9
720P/120FPS 16:9
Power Input: DC 5-12V
FOV: 4K F2.8, 150°(16:9) 165°(4:3)
Weight:18g
Dimension: Camera 19x20mm / DVR 29x29mm
Lens: Dual Lens F2.8/12Mega
Audio: Dual Digital MIC
CPU: DUAL Core dual system
Lipo BatteryCapacity:300mAh
Voltage:11.4v
Continuous Discharge Rate: 30C
Instantaneous discharge rate: 60C
Size: 65mmx18mmx11mm
Weight: 25gConnector: XT30

コピペで済みませんw

ペラは鉄板のEmax Avan、キャノピーはTPU資材っぽく見えますが、Mobula7HDなどに採用されている物と似てる気がしています。

まとめ

入荷日を見てみると33営業日って記載がありますので一ヶ月半程度先になりそうです。

早々にテスター機が出るんじゃないかとも思いますので、YouTubeで動画見つけたらお伝えします。

 

よく読まれている記事

-HD Whoop Drones
-,

© 2017 mocca